Lace Sensor Alumitone Neck & Bridge Copper

Alumitone

This radical departure from pickup design is aluminum based, rather than copper. Result: less resistance, higher output coupled to a "current driven design" as opposed to conventional voltage based pickups. The aluminum water jet cut exoskeleton is then matted to a micro winding using 90% less fine copper wire, a low impedance/high impedance pickup is then created. Broadband response like our single coil version, but voiced for the classic mid range response humbucker tone. Installing two of these Alumitones on your guitar will save you 1/3lb of weigh and increase your guitars resonance!

Specs:

• Position: neck, bridge
• Resistance: 3.4k
• Peak frequency: 2343
• Inductance: 1.4 henries

"Overdriving the alumitone brings out its' great performance, as it cuts through the mix and excels where most single coils start to run off." "The new look for pickups really sets off my guitar like no one else in the room."